Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: June 13, 2025
By putting this over the upper table and underneath the fingerboard a part will project forward on each side of the neck; it must be held in position by one hand, while the other holds the paper file, which will be worked along the sides of the fingerboard, at the same time being held nearly vertical.
When the exact spots for the grooves are marked or pricked, a very small, round or "rat-tailed" file may be used to work the wood down at the spot, care being taken that the file is constantly held in an exact line with the direction of the fingerboard, otherwise when strung up the appearance at the part will be that of distortion and the string will even be checked in its freedom in passing through the grooves, each of which should be made to receive the string not too tightly nor too loose.
To return now to our loose fingerboard, an old fashioned and very clumsy, inefficient way of fastening it after glueing, was to tie some string round it, which of course getting much glue upon it during progress had, when dry, to be torn or washed off.
The picture that gave him the victory and the prize of honour was that wherein he painted Music, in which are depicted three very beautiful young women, one of whom, the most beautiful, is playing a great bass-viol, looking down at the fingerboard of the instrument, the attitude of her person showing that her ear and her voice are fixed intently on the sound; and of the other two, one is playing a lute, and the other singing from a book.
It is sometimes made as a double guide in the adjustment of both the inclination and the elevation of the under part of the fingerboard above the body of the instrument at the junction of the neck. This we will call No. 1. The other, No. 2, is similar, but has the height of the bridge only as a fixture, the rise of the end of the neck above the border being higher and lower at discretion.
"Mamma," said Constance, "if you permit such a thing, I shall hope that memory will be a fingerboard of remorse to you, pointing to Miss Ringgan's pale cheeks." "I shall charge it entirely upon Miss Ringgan's own fingerboard," said Mrs. Evelyn, with her complacently amused face. "Fleda, my dear, shall I request Mr. Olmney to delay his journey for a day or two, my love, till you are stronger?"
These may be made of some hard wood or metal, such as zinc, and if truly made will last any length of time. They should be trimmed to fit some fingerboard that has been ascertained to be just the thing in its arching. It may be as well to observe that some violinists prefer using a rather flatter fingerboard than others, but the medium is without doubt the best, and is not difficult to arrive at.
If I draw the bow above the fingerboard instead of keeping it near the bridge, I have a decided contrast in color. This color contrast may always be established: playing near the bridge results in a clear and sharp tone, playing near the fingerboard in a veiled and velvety one.
The polishing of the neck, or fingerboard with it, may be effected by making a small ball or dabber of about half an inch in diameter of fine grained flannel; this should be covered with another surface of closer material such as calico, but large enough to enclose the little bunch and to be tied up with a piece of string.
The height of each rut above the fingerboard cannot well be given in fractions of an inch, as they must be regulated to the convenience of the performer. A hard, rasping, orchestral player, with a heavy, unsympathetic bow arm, will require the ruts higher above the board than a soloist of refined taste. The relative heights, one with another, must be the same in both cases.
Word Of The Day
Others Looking