United States or Norfolk Island ? Vote for the TOP Country of the Week !
Then "offer" the leg that belongs to the cut, its end projecting an inch or so. If it won't enter, bevel off the sides of the cut very slightly till it will. A good driving fit is what one should aim at. Bevelling the Legs.-The marking out of the bevels will be much expedited if a template is cut out of tin or card.
They ran her into the garage shop and went deep into her vitals, and because she jerked when Bud threw her into second, Bud suspected that her bevel gears had lost a tooth or two, and was eager to find out for sure. Bill looked at his watch and suggested that they eat first before they got all over grease by monkeying with the rear end.
Two brass bevel wheels, about 1 inch in diameter, and purchasable for a couple of shillings or less, should be obtained to transmit the vane movements to the dial arrow. Grooved pulleys, and a belt would do the work, but not so positively, and any slipping would, of course, render the dial readings incorrect.
The cam-shaft is hollow, and serves as a channel for the conveyance of lubricating oil to each of the camshaft bearings. At the forward end of this shaft there is also mounted an air pump for maintaining pressure on the fuel supply tank, and a bevel gear tachometer drive. Lubrication of the engine is carried out by a full pressure system.
The main engine is 10 × 24, operating, by bevel gearing and a 3½ in. vertical shaft, a 4 sided upper tumbler with 21 in. sides. This engine works also a gypsy shaft for swinging, and the conveyer that carries the mud ashore. A steam hoist with 6 × 11 engines raises and lowers the bucket ladder.
This part had been chipped ready for grinding, and the article was evidently unfinished; one side still wanted polishing, and the part opposite the bevel showed signs of tapering, as if a point instead of an edge had been intended. At Axim I split off by gads and wedges a large slice of the grooved rocks described by Burton; it came home with me, and is now lodged in the British Museum.
"Civilisation's struck Coyote Centre good and proper, at last, evidently," he commented. "They'll be having a bevel plate hearse with carved wood tassels and a coon driver next!" He halted, indecisive, and for the first time became conscious that not a human being was in sight.
For A, B, and C cut off pieces of bearing pipe, 1/2, 1/4, and 3/4 inch long respectively, and bevel the ends of B and C as shown, to minimize friction if they rub. File all other ends square. Bore oil holes in B and C, and clear away all the "burr." Make scratches on the bearings to show how far they should be pushed through the case.
Should any one feel desirous to test more minutely the effect produced by a bevel top bath, I would suggest to them to place a frame, so constructed as to hold three sixth size plates, and fit it to the top of the bath, and so arrange it with openings that the plates may be placed, one at the nearest point of the mercury, the second midway, and the third to the greatest distance, and by placing the plates over at one and the same time, the experimenter will be enabled to judge if there exists a difference in the developing.
If the bait is pulled, the bait stick thus forces the plug into the hole in the board, and thus slides the cord on to the bevel, which immediately releases it, and the bow is sprung. So that no matter whether the bait is pushed or drawn towards the front, the trap is equally sure to spring.
Word Of The Day