United States or Guinea ? Vote for the TOP Country of the Week !
But he knew that in another place a template would be laid over his work. An irregular portion like a piece of a jigsaw puzzle would be cut out of it and the rest, perhaps more than half of his work, would be destroyed. It was even possible that all of it was destroyed. Dewforth worked for a firm which made components. Of what, no one said, no one asked. Components, Inc., the firm was called.
Then "offer" the leg that belongs to the cut, its end projecting an inch or so. If it won't enter, bevel off the sides of the cut very slightly till it will. A good driving fit is what one should aim at. Bevelling the Legs.-The marking out of the bevels will be much expedited if a template is cut out of tin or card.
Tubes H must be bent to a template to get them all of the same shape and length, and all the tubes be prepared before any are put in place. If the tubes are set 7/8 inch apart, centre to centre, instead of 1-1/4 inches, the heating surface will be greatly increased and the furnace casing better protected. Assembling.
For this a piece of almost any veneer cut to the exact flow or drawing of the line may be used as a guide or template. The block from which the nut is to be made having been cut quite level, the line can be traced with a fine pointed pencil, or better, a fine pointed knife, and then shaped with a sharp chisel.
The simplest method of getting the marks right is to cut a template out of thin card and apply it to the two ends in turn, using the base of each as the adjusting line. Fret-saw the holes, cutting just inside the lines to allow for truing up with a coarse file. The shelves a and b are 15 inches long, exclusive of the lugs c, c, c, c, and 4-1/2 and 4-3/4 inches wide respectively.
When Overholt had swallowed his cold tea, he got out his drawing materials, stretched a fresh sheet of thick draughtsman's paper on the board, and sat down between the motor that would not move and the little city in which Hope had taken lodgings for a while, and he went to work with ruler, scale and dividers, and the hard wood template for drawing the curves he had constructed for the tangent-balance by a very abstruse mathematical calculation.
He saw over and over again a workman shut down his machine and hunt up the foreman to inquire, perhaps, what work to put into his machine next, and then chase around the shop to find it or to have a special tool or template looked up or made.
It was with gloom he con- sidered on landing at Liverpool that if he were to go home his reception would be of a kind very unpleasant to con- template; for what Troy had in the way of emotion was an occasional fitful sentiment which sometimes caused him as much inconvenience as emotion of a strong and healthy kind.
The notches for the roof stays should not be cut till the roof is being fitted. Use the side frame first made as template for the other. The shelves are notched at the ends, so that their back faces shall be flush with the board side of the frame. Fix the corners with the screws, and plane off the projecting angles of the uprights. When putting on the boards, start at the back of the frame.
It should be just as wide as the legs, and at a point 4 inches from one end run off at an angle of 162 degrees from one edge. Draw with a square a line, EEl, across what is to be the inside of the leg. The template is applied to the end side of the leg and moved up till its sloping edge occupies a position in which a perpendicular dropped on to it from C is 1/2 inch long.
Word Of The Day