Vietnam or Thailand ? Vote for the TOP Country of the Week !

Updated: June 13, 2025


The dotted lines h' h'' show the position of the eccentric rods when the link is in its highest position, and l l' when in mid position. Q. What is Cabrey's arrangement? A. Mr. Cabrey makes his eccentric rod terminate in a pin which works into a straight slotted lever, furnished with jaws similar to the jaws on the eccentric rods of locomotives.

"Then," said the detective, "I'm going to entrust you with that slotted sheet of paper again. For I have an idea, Mr. Greve, that you may get a glimpse of that letter before I do. I'll send a messenger round with it at once." Then a difficulty arose. Manderton had not got the girl's address. They had no address at Harkings. Nor did he know what train Miss Trevert had taken.

This latter and the pencil are held at the proper distance apart by means of a slotted strip of metal and a binding screw. When the instrument is closed, as shown in the figure to the left, it takes up but little space, and may be easily carried in the pocket without the point tearing the clothing, as the binding screw holds the leg firmly against the pencil.

He took the slotted sheet of paper from Robin's hands and laid it over the letter so that it exactly covered it, edge to edge and corner to corner. In this way the greater part of the typewriting in the letter was covered over, and only the words appearing in the slots could be read. And thus it was that Robin Greve, Herr Schulz, and Dr.

This pipe is slotted beneath, and the pieces of wood or metal contain, opposite the slot, a number of small apertures that put the distributer in communication with the interior of the bags. Between these latter there are placed wire cloth frames which hold them in position and facilitate the flow of the filtered liquid. The cut shows the filter provided with a portion of its bags and frames.

The iron piers are each formed of four columns, and the columns consist of two Barlow rails, with a slotted iron plate ½ inch thick let in between the rails, and the whole being riveted together connects each pair of side columns. The details show the system of cross and diagonal bracing. The columns are each supported by four buttresses formed of plates and angle-irons.

The pneumatic hammers had a crank, with a connecting rod or a slotted crossbar on the piston-rod, a piston and a cylinder which formed the hammer-head.

The logs of the walls were faced on two sides and set close together, and were slotted every four feet for rifles. At one of the corners which had no bastions were double gates, also made of logs, bound by cross and diagonal bars, dovetailed and pinned firmly to them. Each hung on huge, triple hinges of iron.

Two half-tubes instead of one slotted tube have been employed, in order to leave a free passage for dirt or wet to fall through the slot in the center rail to the drain space, G. Between chair and chair hewn granite or artificial stone is employed, formed, as shown in the drawing, to complete the surface of the road and to form a continuous channel or drain.

This supplementary valve is worked by a double ended lever, slotted at one end for the reception of a pin on the valve link, the position of which in the slot determines the throw of the supplementary valve, and the consequent degree of expansion. Q. What is the arrangement of expansion valve used in the most approved modern engines?

Word Of The Day

221-224

Others Looking