United States or Nepal ? Vote for the TOP Country of the Week !
This makes them very pliable and increases their toughness, so that they will stand a strain three times as great as a piece of hard rolled sole leather. In manufacturing this belt, the joining together is important. The links must be accurately assorted as to thickness, and the outer links countersunk, to admit the bolt.
The holes in the tube plate next the front of the boiler are just sensibly larger in diameter than the holes in the other tube plate, and the holes upon the outer surfaces of both tube plates are very slightly countersunk.
It was curiously wrought in brass, of an intricate antique pattern which would have puzzled a modern locksmith. He turned the case over, and saw that the bottom had been mortised and screwed. The screws had been deeply countersunk, and were embedded in rust, but a few were loose with age. Colwyn unscrewed these loose ones with his pocket-knife, and then set about unloosening the others.
You must now measure carefully to establish lines over the centres of CC and F. Attach each board to each of these by a couple of screws. All screws in the top of the bench are countersunk 1/8 inch below the surface. Screw the ledge E, of 4 by 5/8 inch wood, on to the back of G, with 2-1/2 inches projecting. This will prevent tools, etc., slipping off the bench. The Vice.
But the most experienced will be awe-struck but the vast extent of strange, countersunk scenery, the multitude of huge rock monuments of painted masonry built up in regular courses towering above, beneath, and round about him. By the Bright Angel trail the last fifteen hundred feet of the descent to the river has to be made afoot down the gorge of Indian Garden Creek.
A hole is bored in the centre somewhat smaller than the knob to which the rubber was fastened, and joined up to one long edge by a couple of saw cuts. Two holes for good-sized screws must also be drilled and countersunk, and a socket for the knob must be scooped out of the lever.
Reassemble the parts, and put in the rest of the holding screws, which should have their heads countersunk flush with the wood. For the shaft select a piece of steel rod 5/32 inch in diameter, and 3 or 4 inches long; for the bearings use two pieces, 3/4 inch long each, of close-fitting brass tube.
Also, the man glaringly destitute of integrity or capacity, but noticed as having a bullet-head, a square jaw, countersunk eyes, and the rest in proportion, is suspected of having the other kind of force in reserve; and we know how he escapes anything like wanton personal indignity in his intercourse with gentle or simple.
Sauntering along the brook that meanders silently through the meadow from the east, special flowers call you back to discriminating consciousness. The sod comes curving down to the water's edge, forming bossy outswelling banks, and in some places overlapping countersunk boulders and forming bridges.
It is like an aqua-marine gem countersunk in the green landscape. Many an hour had Irene and Stanhope passed in dreamy contemplation of it. They had sailed down the lake in the little steamer, they had whimsically speculated about this and that couple who took their ices or juleps under the trees or on the piazza of the hotel, and the spot had for them a thousand tender associations.
Word Of The Day