Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: May 23, 2025
It would be it was being treated as if it were a crate of eggs instead of massive metal, smoothed and polished and lapped to a precision practically unheard of. But just the same Joe was worried. He'd seen the pilot gyro assembly made. He'd helped on it. He knew how many times a thousandth of an inch had been split in machining its bearings, and the breath-weight balance of its moving parts.
The size and shape of the exhaust cam is found in the same manner as above described; the angle through which it operates is greater than that of the air cam, and is shown in fig. 33. A fair margin should be allowed for filing or machining these castings up; the shape and sizes arrived at by the above described method being finished measurements.
The different fragments were finally brought to Colonel Béville, who put them together and corrected the proof sheets. The machining was conducted with the same precautions, each press being between two soldiers. Notwithstanding all possible diligence the work lasted two hours. The gendarmes watched over the workmen. Béville watched over St. Georges.
The crank-case of this two-cylinder vertical Daimler engine was the only part made of aluminium, and even with this no attempt was made to attain lightness, for a circular flange was cast at the bottom to form a stand for the engine during machining and erection.
Tin tacks and some considerable machining for mother had lent her the help of her little "common sense" awhile had done it all; and Ruth's room, with its oblong of carpet, which Mrs.
"Please, miss, 'Annah says as 'is pa've took him with him down the village." Jan laid her sewing on the table and got up. "Is Earley in the garden?" "Yes, miss. I ast Earley an' 'e says the same as 'Annah. Mr. Tancred 'ave took Master Tony with 'im." Anne went away, and Jan and Meg, who had stopped her machining to listen, stared at each other across the table.
He kicked her down stairs the other night, and the children all screaming, and her shrieking, and him swearing. It was a nice time." Once more the machining interrupted the conversation, which thus was renewed from time to time in the pauses of the noise. The room being "tidied," Mrs.
Figs. 8 and 9 show the method of machining the cylinders and pistons, the whole of which can be done by ordinary lathes, which is evidently a great advantage in the event of reboring, etc., being required in the colonies or other countries where special tools are inaccessible. Figs. 11 and 12 are sections which explain themselves. The Engineer.
He had been clever: had penetrated even the model-office, peered at detailed draughtsman's-plans, developed from the original specifications, as well as at orders for Krupp plates, frames, etc.; had listened in the yard to the talk of four naval men acting as a Board of Inspection; was able to give details of the machining of enormous processed plates to sizes determined by templates, the length of pan-headed rivets, the specific gravity of an average cubic foot, the scarfing of edges, the accumulation of prepared material.
"Well, how goes it, Reb Méshe?" said Reb Shemuel with his cheery smile, noticing Moses loitering. He called him "Reb" out of courtesy and in acknowledgment of his piety. The real "Reb" was a fine figure of a man, with matter, if not piety, enough for two Moses Ansells. Reb was a popular corruption of "Rav" or Rabbi. "Bad," replied Moses. "I haven't had any machining to do for a month.
Word Of The Day
Others Looking