Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: June 21, 2025
There were two small pipes, one for each kind of drink, leading from the bottom of the can round by the side of the man to the front, with stopcocks at the end, where he could draw out the drink conveniently. There was also a little rack to hold the glasses. There were three glasses; for the man sometimes had three customers at a time.
As shown in the diagram, the "potetometer" consists essentially of a glass tube, a d, open at both ends, and blown out into a bulb near the lower end; an aperture also exists on either side of the bulb at or about its equator. The two ends of the main tube are governed by the stopcocks, a and d, and the greater length of the tube is graduated.
Wouldn't it be edifying to hear him string the yarn of these new words! to hear him tell of his engineer and ploughman; of his pokers and pitchforks; of six-horse power, valves, revolutions, stopcocks, twenty pounds of steam, etc.; mixing up all this ridiculous stuff with yearling-calves, turnips, horse-carts, oil- cake, wool, bullocks, beans, and sheep, and other vital things and interests, which forty centuries have looked upon with reverence!
The proper taper for both these cones is the same as that used in stopcocks of similar size. The hexagonal carbon can easily be made by carefully filing down an electric light carbon, and finally impregnating it with paraffin or beeswax, and is extremely useful wherever a conical surface has to be formed from the inside of a tube.
There was an ornamentation of "knops" or "gourds," in two rows, about the "brim" of the reservoir; and it must have been supplied in its lower part with a set of stopcocks, by means of which the water could be drawn off when needed. Representations of the "molten sea" have been given by Mangeant, De Voguee, Thenius, and others; but all of them are, necessarily, conjectural.
The enormous locomotive-engine, with its driving-wheels that stood higher than a man's head, impressed him mightily, for all that the monster's burning heart had grown cold and its stentor breathing had been hushed forever. He climbed into the cab and wondered hugely at the multiplicity of stopcocks and levers and cabalistically lettered dials.
The tail is allowed to remain on piece a, as a sort of guide in grinding, and should therefore be in the axis of the tube and have rather thick walls. Grind with emery or carborundum, as described under a previous head. This prevents excessive grinding of one-half of the joint in order to remove a defect in the other half, and is the method commercially used in making stopcocks.
I open some stopcocks, the tanks fill, the boat sinks, and it's exactly flush with the surface of the water." "Fine, captain, but now we come to a genuine difficulty. You're able to lie flush with the surface of the ocean, that I understand.
=Regrinding.= This is sometimes necessary to make stopcocks tight, when the grinding has not been properly done in the factory. For this, a very little fine flour of emery or carborundum is the best and quickest. If this is not at hand, some clean sand may be ground in an agate mortar, and if possible sieved. Only material which passes the 100-mesh sieve should be used.
Word Of The Day
Others Looking