Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: May 28, 2025
Thus the small mill at Newburg grew from the capacity of turning out thirty tons of re-rolled rails to its present capacity of sixty tons, beside the addition of a puddling mill, a merchant bar mill, a wire rod mill, two blast furnaces, spike, nut and bolt works.
Now and again a desert plant, uprooted from its arid home, eddied joyously past her, satiated for once of its lifelong thirst; and farther out she thought to have a glimpse of some dead and whitish animal. But these were minor blemishes on a great, lustrous ribbon of silken black, unrolled and re-rolled from darkness into darkness.
"And affairs at the mill?" inquired Felipe, with a movement of the hand demanding pardon if the subject should be painful. "The wheel is still," replied Tomaso, with that grand air of indifference with which Spain must eventually go to the wall. He slowly unrolled and re-rolled a cheap cigarette, and sat down on the bench opposite to Felipe.
Having re-rolled it between her fingers, she placed it within the gripe of a pair of small golden pincers. This done, she held one end to the coals that lay upon the brazero, and ignited the paper. Then, taking the other end between her thin, purlish lips, she breathed forth a blue cloud of aromatic vapour.
There was a little pause while Fisette sheared thin shavings of tobacco from a dog-eared plug. He rolled them into a ball between his tawny palms, thoughtfully unpicked the ball, re-rolled it more loosely, abstracted a match from the inside band of his tattered hat and began to suck wetly at a gurgling pipe. "What's that?" he said presently. "I asked you did you come far?"
"The rolls" are heavy cylinders of cast iron placed almost in contact, and revolving rapidly by steam-power. The bloom is caught between these rollers, and passed backward and forward until it is pressed into a flat bar, averaging from four to six inches in width, and about an inch and a half thick. These bars are then cut into short lengths, piled, heated again in a furnace, and re-rolled.
At the end of four years this has to be re-rolled at a cost of $30 per ton, or $3,300 more. This is equal in eight years to an annual depreciation of $1,237 per mile. A sixty-pound rail requires 94 tons to a mile, costing for the best iron that can be rolled $80 per ton, or $7,520 per mile.
Word Of The Day
Others Looking