Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: June 21, 2025
Soldering the disc to the spindle is most easily effected with a blowpipe or small blow-lamp. The Boiler. In the centre of the boiler make a dent, to act as bottom bearing for the spindle. From this centre describe a circle of 5/8-inch radius. On this circle must be made the steam port or ports.
Whip it to a froth, remove the peel, and serve the cream in a dish. SOLDERING. Put into a crucible two ounces of lead, and when it is melted, throw in an ounce of tin. This alloy is that generally known by the name of solder. When heated by a hot iron, and applied to tinned iron, with powdered rosin, it acts as a cement or solder. It is also used to join leaden pipes, and other articles.
Here, a is the copper or silver wire, and b is a soldering made with a very fusible metal and securing a continuity of the circuit. Each extremity of the wire, a, is connected with a heavy ring, c, of copper or other good conducting metal.
It is invaded by various grasses and reeds which have learned to grow in salt and brackish water; the marsh, laid bare only at low tide, is built above high tide by wind drift and vegetable deposits, and becomes a meadow, soldering the sand reef to the mainland.
But when, after fresh explanations, he understood that the roofing was so worn and damaged that it required to be changed entirely, he suddenly departed from his lofty affability and began to protest, declaring that he could not possibly expend in such repairs a sum which would exceed the whole annual rental of six hundred francs. "Some soldering," he repeated; "some soldering; it's understood.
The engine illustrated in Figs. 53 to 66 will give sufficient scope for energy and handiness with drill and soldering iron. The writer made an engine of the same kind, differing only from that shown in the design of the crosshead guides, without the assistance of a lathe, except for turning the piston and fly wheel the last bought in the rough.
First polish the iron you wish to silver, wet it well over with No. 21 soldering fluid; then having procured that kind of silver-plate which is tin on one side and silver on the other, place it evenly on, with the tined side next to the iron, then place it on the fire until the silver-plate melts down, then at once take it from the fire, and it will be firmly attached to the iron, and will be excellent plate; yet No. 23, the cold method, is to be preferred in most cases.
Women and cows are always kickin'! If the blarsted cow hadn't kicked a hole in the pail, there'd be no need of Mary kicking for a new one. But dough IS dubious soldering. Mary says it's bad enough on the dish pan, but it positively ain't hilthy about the milk pail, and she is right. We ought to have a new pail. I guess I'll get it first, and fill up on what's left. One for a quarter will do.
We do not here find the geometrical lid of the Leaf-cutters, the pile of disks tight-set in the mouth of the jar. The bag is closed with a cotton sheet whose edges are soldered by a felting-process to the edges of the opening. The soldering is so well done that the honey-pouch and its cover form an indivisible whole. Immediately above it, the second cell is constructed, having its own base.
Though stays will prevent the ends of the boiler blowing off, it is very advisable to rivet them through the flanges to the ends of the barrel, as this gives mutual support independently of soldering or brazing. Proper boiler rivets should be procured, and annealed before use.
Word Of The Day
Others Looking