United States or Cuba ? Vote for the TOP Country of the Week !


The best solder for iron is good tough brass, with a little borax. Take of brass, 6 parts; zinc, 1 part; tin, 1 part; melt all together, mix well, and pour out to cool. Silver, 19 parts; copper, 1 part; brass, 2 parts; melt all together. Fuse together 2 parts of copper, and 1 of zinc. Fuse together 5 parts of silver, and 1 part of brass. GOLD SOLDER No. 1

Bradwardine, who, notwithstanding his peculiarities, was much respected in the country, he took advantage of the foray of Donald Bean Lean to solder up the dispute in the manner we have mentioned.

Finally twist the ends of each pair of short wires to the free ends of the insulators and then twist the free ends of the wires together. For the leading-in wire that goes to the lightning switch take two lengths of wire and twist one end of each one around the aerial wires and solder them there.

Thus at the restoration, the Presbyterians, Anabaptists, Independents, and other sects, did all with very good reason unite and solder up their several schemes to join against the Church, who without regard to their distinctions, treated them all as equal adversaries.

And now that hateful Sammy's found it and brought it back, and I've sent him your solder, and Debby's promised me she wouldn't tell you about the pork, and I I'm no better than the rest of 'em that lie and lie and don't let their men-folks know!" Letty was sobbing bitterly, and David drew her into his arms and laid his cheek down on her hair. His heart was aching too.

So has it always been with chemistry, the most cosmopolitan of sciences, the most secret of arts. Quietly and stealthily it crept through the world; the tinker brought it with his solder and his flux; the African tribes who were the first workers in iron passed it on to the great metallurgists who forged Damascan and Toledan steel.

When adjustment is satisfactory, mark the position of the foot on the bed, solder foot to barrel, and drill and tap the foot for the holding-down screws. Don't forget that the distance between pump and cylinder gland must be at least 1-1/3 times the stroke. The valve motion can then be taken in hand.

Shopmen stood at their doors and cried, "Rally up, rally up, buy, buy, buy!" venders shouted saloop and barley, furmity, Shrewsbury cakes and hot peascods, rosemary and lavender, small coal and sealing-wax, and others bawled "Pots to solder!" and "Knives to grind!"

To hook-up the set connect the leading-in wire to one end of the primary coil, or stator, of the variocoupler and solder a wire to one of the taps that gives the longest wave length you want to receive.

Be careful not to unsolder the spindle bearing, a thing which cannot happen if the bearing is kept cool by an occasional drop or two of water. A little extra solder should be applied round the points where the ports will be. The Steam Ports. If you have any doubt as to your boiler's capacity, begin with one hole only, and add a second if you think it advisable.