Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: May 27, 2025
Affix the pulley and stirrup, and adjust the spindle longitudinally until the rotor just does not rub the casing. The soldering on of the cap of A completes operations.
Second, the governor weights move outward on a parallel motion opposed directly by spring thrust, thus relieving the fulcrum entirely of spring thrust. Third, the lay shaft driving the governor oil pump and reciprocator is located underneath the main turbine shaft, so that the rotor may be readily removed without in the least disturbing the governor adjustment. The Valve-Gear
When the variocoupler is adjusted for receiving very long waves the rotor sets at right angles to the stator and, since when it is in this position there is no mutual induction between them, the tickler coil serves as a loading coil for the detector plate oscillation circuit.
The lower screw should then be advanced until the under half of the thrust bearing pushes the rotor against the other half of the thrust bearing, and from this position it should be pushed back ten or more one-thousandths, to give freedom for the rotor between the thrusts, and locked.
Now connect one end of the secondary coil, or rotor, to one post of a .0007 mfd. variable condenser, the other post of this to one end of the grid coil and the other end of this with the remaining end of the rotor of the variocoupler.
The Parsons turbine utilizes a combination of these two methods. Between the rows of the blading upon the rotor extend similar rows of stationary blades attached to the casing or stator. In passing through this row of blades it is further expanded from pressure P to P and helps to push the moving blades along by the reaction of the force with which it issues therefrom.
"Reckon that can be arranged. You drove in, hey? But you didn't drive into town. Instead, you parked in the wash. Now, as sheriff, I find that mighty interesting. You wouldn't have parked there unless you didn't want to be seen. Only I suspect you were seen, and whoever did the seein' walked off with your distributor cap and rotor. Unless you have 'em, which I doubt.
This reservoir merely took the place of some hundreds of thousands of acres of timbered-off forest which once had controlled floods more effectively. Without a word, Soames slanted the 'copter down. Presently it hovered delicately over the dam's crest and at its very center. It touched. The rotor ceased to whirl. The motor stopped. There was a great silence. Fran scrambled down.
Under these pads are liners 5, 10, 20, and 50 thousandths in thickness. By means of these liners the rotor may be set in its proper running position relative to the stator. This operation is quite simple. Remove the liners from under one bearing pad and place them under the opposite pad until a blade touch is obtained by turning the rotor over by hand.
This done connect one terminal of the tickler coil which is on the rotor of the variometer to the plate of the detector and the other terminal of the tickler to the other post of the .001 condenser and around this shunt your headphones. A Long Wave Receiving Set.
Word Of The Day
Others Looking