Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: July 3, 2025
The crankshaft has a single throw, and is made in two parts to allow the cage for carrying the big end-pins of the connecting rods to be placed in position. The casing is in two parts, on one of which the brackets for fixing the engine are carried, while the other part carries the valve-gear. Bolts secure the two parts together.
Further, at the introduction of this type of engine it was seen that crankshaft vibration, an evil of the early vertical engines, was practically eliminated, as was the want of longitudinal stiffness that characterised the higher-powered vertical engines.
In Alexandria, the girl "did not see why they should pack up to stop a night in Cairo." What if the crankshaft could be repaired sooner than they supposed? Then they would be wasting time. But she was overruled, and just before sunset they drove up to one of the most beautiful hotels in the world.
The arrangement of the cylinders in Vee form over the crankshaft, enabling the pistons of each pair of opposite cylinders to act upon the same crank pin, permits of a very short, compact engine being built, and also permits of reduction of the weight per horsepower, comparing this with that of the vertical type of engine, with one row of cylinders.
The crankshaft is of nickel steel, made hollow, and mounted on ball-bearings in such a manner that practically a combination of ball and plain bearings is obtained; the central web of the shaft is bent to bring the centres of the crank pins as close together as possible, leaving only room for the connecting rods, and the pins are 180 degrees apart.
A very simple carburettor of the float less, single-spray type was used, and the mixture was passed along the hollow crankshaft to the interior of the crank case, thence through the automatic inlet valves in the tops of the pistons to the combustion chambers of the cylinders.
For these engines, castor oil is the lubricant usually adopted, and it is pumped to the crankshaft by means of a gear-driven oil pump; from this shaft the other parts of the engine are lubricated by means of centrifugal force, and in actual practice sufficient unburnt oil passes through the cylinders to lubricate the exhaust valve, which partly accounts for the high rate of consumption of lubricating oil.
A scavenging pump of the rotary type was employed, driven by means of gearing from the engine crankshaft, and in order to reduce weight to a minimum the vanes were of aluminium. This engine was tried on a biplane, and gave very satisfactory results. American design yields two apparently successful two-stroke cycle aero engines.
After the piston has again covered the exhaust ports the mixture begins to be compressed, thus automatically closing the inlet valve. Ignition occurs near the end of the compression stroke, and the working stroke immediately follows, thus giving an impulse to the crankshaft on every down stroke of the piston.
There are certain technical details which distinguish an airplane motor from an automobile motor, but a man who knows automobile engines can master the airplane motor in short order. Generally speaking, the airplane motor differs from the automobile motor in shape. The Liberty type of engine is V-shaped, with both sets of cylinders driving toward a common center, the crankshaft.
Word Of The Day
Others Looking