Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: May 9, 2025
They have a capacitance of 1 mfd. and will stand 750 volts. These condensers cost about $2.00 each. The Filter Reactance Coil. It consists of a coil of wire wound on a soft iron core and has a large inductance, hence the capacitance of the filter condensers are proportionately smaller than where a small inductance is used which has been the general practice.
Now connect one end of the tickler coil with the detector plate and the other post to the fixed .001 mfd. condenser, then the other end of this to the positive or carbon pole of the B battery. Finally, shunt the head phones and the .001 mfd. fixed condenser and you are ready to try out conclusions. A Regenerative Audio Frequency Amplifier Receiving Set.
All of the apparatus for this C. W. telegraph transmitting set is the same as that described for the 100 and 200 mile sets but you will need: one or two 50 watt oscillator tubes with sockets; one key condenser that has a capacitance of 1 mfd., and a rated potential of 1,750 volts; one 0 to 500 milli-ammeter; one aerial ammeter reading to 5 amperes, and an A. C. power transformer for one or two 50 watt tubes.
Begin by connecting one post of the ammeter with the wire that leads to the aerial and the other post of it to one end of the tuning coil; connect clip 1 to one terminal of the .002 mfd. 3,000 volt aerial condenser and the other post of this with the ground.
This is made to take care of a 10 volt current and it costs $10.00. The Filament Storage Battery. This must develop 12 volts and one having an output of 40 ampere-hours costs about $25.00. The Protective Condenser. This condenser has a capacitance of 1 mfd. and costs $2.00. The Motor-Generator.
Begin by connecting one post of the ammeter with the wire that leads to the aerial and the other post of it to one end of the tuning coil; connect clip 1 to one terminal of the .002 mfd. 3,000 volt aerial condenser and the other post of this with the ground.
For this experimental continuous wave telegraph transmitter get the following pieces of apparatus: one single coil tuner with three clips; one .002 mfd. fixed condenser; three .001 mfd. condensers; one adjustable grid leak; one hot-wire ammeter; one buzzer; one dry cell; one telegraph key; one 100 volt plate vacuum tube amplifier; one 6 volt storage battery; one rheostat; one oscillation choke coil; one panel cut-out with a single-throw, double-pole switch, and a pair of fuse sockets on it.
Intermediate Wave Set With Loading Coils. For this intermediate wave set you can use either of the short-wave sets described in the foregoing chapter. Approximate Wave Length in Meters in Millihenries Inductance .001 mfd. Variable Mounted Appx. Air Condenser. on Plug These and other kinds of compact coils can be bought at electrical supply houses that sell wireless goods.
The only differences between this and the preceding transmitter are: the magnetic modulator, if you use one, should have an output of 3-1/2 to 5 amperes; you will need two 50 watt oscillator tubes with sockets; two 150 watt rectifier tubes with sockets; an aerial ammeter that reads to 5 amperes; three 1 mfd. filter condensers in parallel; two filter condensers of 1 mfd. capacitance that will stand 1750 volts; and a 300 milliampere filter reactor.
For this experimental continuous wave telegraph transmitter get the following pieces of apparatus: one single coil tuner with three clips; one .002 mfd. fixed condenser; three .001 mfd. condensers; one adjustable grid leak; one hot-wire ammeter; one buzzer; one dry cell; one telegraph key; one 100 volt plate vacuum tube amplifier; one 6 volt storage battery; one rheostat; one oscillation choke coil; one panel cut-out with a single-throw, double-pole switch, and a pair of fuse sockets on it.
Word Of The Day
Others Looking