Vietnam or Thailand ? Vote for the TOP Country of the Week !
Updated: May 7, 2025
Commence by fixing a line of warp-thread along the exterior side of the coat-stave, making it secure to the bar at both ends. It is important that each loop should be of exactly the same size; this can be ensured by temporarily fixing a rod across the loom at the point where the loops will encircle the warp-thread, and then taking the loop round this bar as well as round the thread.
The lower roller is next turned round until the metal pin is made quite firm in its place by the warp-threads passing across the face of the groove. The warp will now be fixed in the loom as shown in the drawing in fig. 170. The placing of the coats upon the coat-stave is the next part of the preparatory work.
It can be taken out and exchanged for another with a different divisioning, if necessary; without doing this, however, it is quite possible to put at intervals two threads through one division, or to pass over one occasionally if need be. The threads are next fixed in the lower roller. The coat-stave can be seen projecting from near the top of the loom.
These threads make fine backgrounds, and they can be used in many ways upon the design; it is a common practice to carry out the lighting of draperies and of other parts in real gold, just as they are treated in illuminated manuscripts. Warping the Loom Dressing the Coat-Stave Tracing the Pattern upon the Threads.
Word Of The Day
Others Looking