Vietnam or Thailand ? Vote for the TOP Country of the Week !
The bevel wheels at the end of the rollers are naturally covered as a protection against accidents. In many machines safety appliances are fitted at the feed end so that the machine may be automatically stopped if the operative is in danger.
Beyond was a glitter of white and gold, the scarp of Moriah and its breast of stone, the Tyrian bevel of Solomon, the porphyry of Nehemiah, the marble that Herod gave; ascending terraces, engulfing porticoes, the splendor of Jerusalem at dawn.
"What was the most remarkable chance you ever had to make a million, and did not?" He threw back his head, smiling shrewdly. "When by accident my enemy got hold of a telegram meant for me. I was standing behind a frosted glass door, and through the narrow bevel of clear glass I watched him read it. I never saw a struggle like that.
The pistons of the two cylinders are connected by rods, D, to opposite cranks on the shaft, E. This shaft, by means of bevel gear, F, works a revolving cylindrical valve, G, situated in a casing between the two cylinders. The lowest part of this casing is supplied with combustible gas and with air, in proportions capable of being regulated by stopcocks or valves.
Whenever leaves run out to a fine edge they also should have a small bevel like this in order to avoid an appearance of weakness which acute edges always present. As a general rule leave as much wood as possible about the edges of leaves as you want shadow from them dipping them only where you are sure the variety will be effective.
Thus the point of cutting off is varied at will while the engine is running, by means of the hand wheel on the horizontal axis of the bevel pinion, and a small worm on the same axis turns the index, which points out upon the dial the distance followed.
=Cutting the Glass.= For this purpose a "glass-knife" is preferred to a file, if the glass is cold: if it is hot a file must always be used, and its edge slightly moistened to prevent drawing the temper. The glass-knife is simply a flat piece of hard steel, with the edges ground sharp on an emery wheel. The bevel of the edge should be from 30 to 60 degrees.
It may be purchased at hardware supply depots in the form of strips an inch and a half wide, by one-thirty-second thick, and is much easier to work than the tempered variety. Then taking three-eighths number .22 gauge steel or brass tubing, we smash it to a short bevel on the anvil, file off the corners and cut it to a length of an inch and three-quarters. This makes the haft or socket.
Trim off the corners till the shape is nearly round; next lay the leather on a flat substance and bevel off the edges until they are as thin as you can make them. Now, without cutting through to the under side, cut a hole through the top of the leather, just large enough to force the end of a strong string through. Before using, soak the leather till it is soft.
I noted a crease on each leg of the deceased man's trousers as if they had been turned up half-way to the knee; and in the waistcoat pocket I found the stump of a 'Contango' pencil. On the floor of the bedroom, I found a portion of an oval glass somewhat like that of a watch or locket, but ground at the edge to a double bevel. Dr.
Word Of The Day