United States or Ghana ? Vote for the TOP Country of the Week !


T3 and T4 are connected with one of the line wires; T1 with the other wire through a battery, B; T3 with the other wire through the buzzer, R. If the stem of K is depressed to make contact with M, the electric circuit of which the battery, B, forms part is completed, and the buzzer at the other end of the lines comes into action.

The three contacts C1 C2 C3 must be the same distance apart as the centres of the link heads, and so situated as to lie on the arcs of circles described by the links. The binding post T3 is connected with the two outside contacts which may be flat-headed brass nails driven in almost flush with the top of the wooden base by wires lying in grooves under the base, and T4 with the central contact.

If you do not possess any brass strip, the lever may be supported on wooden uprights glued and screwed to the base. Contact M is a small piece of brass attached to the base by a screw at one end and by T1 at the other. K was drilled near the end to take the short coil of insulated wire joining it to T2, and O was similarly connected with T4. The spring, S, should be fairly strong.

To carry out this idea the inlet valves are furnished with two guides, which, passing upward through the stuffing-box, are attached to a hard steel cross piece, which receives the action of a bent catch turning on a pin attached to the levers, t1, t2, t3, t4.

A wooden lever, L, is pivoted on a support, A. Passing through it at the forward end is a metal bar having at the top a knob, K, which can be grasped conveniently in the fingers; at the other a brass screw, O, which is normally pulled down against the contact, N, by the spiral spring, S. The contact M under K is in connection with the binding post T1 and N with binding post T3; K is joined up to T2, and O to T4.